Edelbrock 33503 Instrukcja Użytkownika Pobierz pdf

INSTALLATION INSTRUCTIONS

FOR 1992-1995 VIPER SHOCKS

Catalog #33503

§ Please read these instructions entirely before beginning. Proper installation is a must to realize the

maximum performance improvements.

IMPORTANT NOTES:

§ Upon initial inspection, some new shocks may have a small amount of oil in the area of the seal. This is a

normal occurrence following manufacture and does not indicate a problem with your shocks.

§ Any time you are working under a vehicle, be sure to use the proper jack stands and tire chocks to prevent

any shifting or slipping of the car. Never use a jack only to support the vehicle while changing shocks.

§ Inspect shock brackets or mounting points before installation to make sure they are not broken or bent.

§ Do not attempt to disassemble the Edelbrock IAS shocks. Contact your point of purchase or Edelbrock

for any necessary service or repairs.

INSTALLATION INSTRUCTIONS

Step 1 Support Viper by frame with jack stands or

on a lift.

Step 2 Remove all four wheels.

Step 3 Removal of front shocks:

Fig. 2

An aluminum block should be placed between arm and

hammer to minimize marking control arm, do not hammer

directly on the arm. It should only require a couple of

sharp taps with a hammer in order to pop from seat. Do

both left and right sides, and remove nuts.

3(a) Loosen upper and lower shock nuts, but do not

remove the bolts at this time. (See Fig. 1).

3(b) If the lower shock nut is to rear, the lower sway

bar end link must be removed in order for the

bolt to have enough clearance for removal.

(See Fig. 1).

Fig. 1

3(c) Removal of lower sway bar end link

If the tool for unseating the sway bar from the

lower control arm is not available, the following

procedure may be used. (The sway bar end

link is held in place with a tapered seat).

In order to remove:

3(c)1 Loosen lower sway bar end link nut, do

not remove the nut completely.

3(c)2 Place jack under the nut.

3(c)3 Jack up and apply pressure to the nut.

3(c)4 Tap control arm with hammer.

(See Fig. 2).

3(d) Remove upper and lower bolts to remove

shock. It may need a little gentle persuasion

with a pry bar (See Fig. 3). Bolt should come

out by hand.

Fig. 3

1 2 3 4

Podsumowanie treści

Strona 1 - Catalog #33503

INSTALLATION INSTRUCTIONS FOR 1992-1995 VIPER SHOCKS Catalog #33503 § Please read these instructions entirely before beginning. Proper installati

Strona 2

Step 4 Removal of rear shock Step 7 Assembly of IAS shocks 4(a) Loosen upper and lower nuts. 4(b) In order to remove bolts, they may need a

Strona 3

8(e) Align end of coil spring to lowest point on spring seat before releasing the spring compressor. (See Fig. 11). Fig 11 Step 9 Assembly of Re

Strona 4 - Revised 2/01

10(b) Front sway bar end links may now be reinstalled. Install both left and right at the same time. After both sides are in position, the end lin

Komentarze do niniejszej Instrukcji

Brak uwag

Edelbrock 33503 Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Do samochodu Edelbrock 33503. Edelbrock 33503 User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Do samochodu Edelbrock 33503