Edelbrock 2010 Instrukcja Instalacji Pobierz pdf (Strona 12)

Part #1596, 1597, 1598, 1599

Brochure #63-1598

Rev. 9/19/14 - QT/mc

Edelbrock E-Force Supercharger System

2010-2014 Camaro SS

Installation Instructions

Page 10

27. Use a flat head screwdriver to loosen the worm clamp

holding the inlet tube to the air box lid then remove the air

box lid by pushing the lock tabs back.

28. Disconnect the passenger side PCV tube from the valve

cover then use a flat head screwdriver to loosen the worm

clamp retaining the air intake tube to the throttle body.

Remove the air intake tube and PCV hose.

29. Use a 15mm socket and a breaker bar to loosen the

tensioner and remove the serpentine belt.

30. Disconnect the throttle body control connector on the

passenger side of the throttle body.

31. Use a 10mm socket to remove the four bolts retaining

the throttle body and set it aside.

32. Push down the white tab on the front EVAP hose fittings

and disconnect them from the manifold and the EVAP

solenoid.

33. Disconnect the Manifold Air Pressure sensor and EVAP

solenoid electrical connectors.

NOTE: 2013 model years disregard Step 34 and proceed to

Step 35. 2014 model years proceed with Step 34.

34. Disconnect the PCV tube from the engine valley cover.

NOTE: Step 35 only pertains to 2013 model years. Please

disregard otherwise.

35. Remove the driver side PCV on the rear of the diver side

valve cover and on the passenger side of the throttle body.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

Brak uwag

Edelbrock 2010 Instrukcja Instalacji Strona 12