Edelbrock 2010 Instrukcja Instalacji Pobierz pdf (Strona 41)

Part #1574, 1575, 1576

Brochure #63-1574

Rev. 9/24/14 - QT

Edelbrock GM LS3 Supercharger System for

2010 and later Grand Sport Corvettes

Installation Instructions

Page 33

E-mail Edelbrock Your Stock Vehicle Calibration

In the rare occurrence that you encounter an error message that reads “Calibration not supported” during

the PCM flashing procedure on page 10, you will need to e-mail your stock vehicle calibration to Edelbrock

at [email protected]. Otherwise, disregard this step.

• Begin by downloading the SCT device updater software to your computer; it can be downloaded from: http://www.

sctflash.com/software/SCTDeviceUpdater.exe

• Put the car into Acc mode but do not start it.

• Connect the supplied PCM cable from the tuner to the OBD-II connector.

• Select PROGRAM VEHICLE, arrow over to UPLOAD STOCK, press SELECT and follow the prompts on the

screen.

• If the upload fails, you will be asked to AUTO DETECT, press SELECT and follow the prompts on the screen. If the auto

detect fail, then please contact Edelbrock Tech support @ 800-416-8628

• Once the stock calibration has loaded, disconnect the programmer from the OBD-II connector and connect it to your PC

using the supplied USB cable.

• Open the SCT software and select the button on the lower left hand side that reads GET STOCK FILE FROM DEVICE.

Follow the instructions on the screen.

• Once the download is complete, e-mail the file to [email protected] or call 1-800-416-8628 and our tech

support staff will assist you in e-mailing the file.

NOTE: The subject line of your e-mail should be “file update needed”, The file will automatically be labeled using your

VIN # followed by “.sul “ (XXXXXXXXXXXXX.sul)

• Once we have this file we can update the tune to work with your application, then we will e-mail you the custom tune

which you may use until the release version is available. (This process can usually be completed within 1 to 2 business

days)

• Download the new tune to the programmer using the directions received with the custom tune.

• Re-try the test flash procedure using the custom tune.

1 2 ... 36 37 38 39 40 41

Brak uwag

Edelbrock 2010 Instrukcja Instalacji Strona 41